Well the windshield came in while I was out last week, well wrapped and no scratches.
I do have a question though. When I took it from my office last Friday, I missed the gasket and weather strip. So I installed it using my rubber weather strip. It fit nice, but would like to do the full install now with the kit that came with the new shield.
It has two foam 1/4" x 1" one side sticky black foam. Does this go on the fairing at the same height as the blackout on the rear of the shield or does it work better on the shield. The info sheet said to do the fairing, but they are very vague on where to place the foam.
Can someone shed some light on the install?
As far as the wind, it seems a lot better and the BSR said less wind as well. I thought I bought too tall, but after riding it for a hundred miles, it seems about right. I can see easily over it and there's very little if any buffeting.
So for now, it seems to be okay. I'm sure other brands of the same height would be just as good, so I'm not getting into that.
Thanks again for the input.
If anyone can help me with the foam strips, I'd be greatly appreciative...