Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Bloomer]

Are these the same as 2015 CVO Limited?

The numbers in the picture. Dealer will install them tomorrow.

[Hdolfje]

 The dealer ordered the ones from the 2015 limited

[Hdolfje]

Picture

[Chains]

Never had a problem with my heated grips on my 06. Problem now at 70,000 miles, the rubber inserts are tacky to the touch and the chrome is starting to wear off the grips.  Looks like I will wear them out before they stop working.   Do I have to refish new wires when I replace them?

[porthole]

Never had a problem with my heated grips on my 06. Problem now at 70,000 miles, the rubber inserts are tacky to the touch and the chrome is starting to wear off the grips.  Looks like I will wear them out before they stop working.   Do I have to refish new wires when I replace them?

Off topic for a moment.

Chains, what lights are you running?

[Wild Hog 4]

Picture

cool! {or rather hot should i say!},
i think i will be fitting the slipstream heated grips to my 2015 cvo when it arrives,as i dont personally like the triangular stipple grips this year.

[Chains]

Off topic for a moment.

Chains, what lights are you running?

V
Truck Light  LEDs headlight and running. Love them. Bought them on eBay a couple years back.  got all three under $300.00 if I remember right.

[skyking650]

Mine are installed and working fine.  Just in time for the first freeze!  They are the CVO grips from HD.  Wire through the handlebars.  I do notice that the left grip warms up quicker then the right, but not a big deal.

Ride Safe!

[Kodas]

Does anyone know if the heated hand grip kit #56100107 will work on a 2016 CVO SG. They look the same as the grips on the CVO Limited but a lot cheaper than the individually priced grips.

[Cat Eye]

They will work just fine....if you install as per the directions.

If you want to run the wire internally on the left side of the handle bars you will need to make some modifications to the left grip
1) Cut off the fuse block because it is to big to slide through the bar
2) Cut a channel in the grip end so the wire will not be pinched in the grip clamp when tighten down by the switch box.
I did this on my limited and softail with little difficulty.

The last ones I installed on my CVO Street Glide and  Road King, I ran the wire on the outside as per the instructions....I just ran the wired under the switch box and wire tied along the clutch cable. Not noticeable at all.

Also, no need to run wire to battery.  Just tie into the  P&A  circuit

If you get stuck please feel to PM me.

 

[Kodas]

Thanks for the quick response!