I read (online) that Jim's recovery was being done inside a well padded Bushtec trailer.

Don I wish to God it was. Sure would beat laying on my back in a hospital bed. My days of trailer flipping are pretty much over.  Once I heal enough to get out of here it’s time to enjoy the rest of my life. 

Welcome from Toronto, Canada.

Welcome to wonderful site from Southern Ontario.

Very cool pics.

I guess the message to the cricket players is to "hop to it" and finish the game.  Whaw, whaw, whaw.   

                        Sorted out!!

         I tried something I saw on YouTube  by GlidePro Motor Mount Install

     He says to leave the mount fixings lose then go for a ride that will let the motor find it's  place to settle,  then tighten the to side bolts of the mount and the centre one  only snug it up so you can still move it back and forth,  job done.

      That's what I did and the issue is solved it's back too smooth riding. 

Gawdammit!!  That's what happens when you don't read on through a thread before answering!   

  Any suggestions on motor vibration 07 ultra classic?

New Swingarm stabilisers installed front mount replaced with a Drag Specialties mount .

Q. Should the motor be pulled forward before tightening bolts up?

At idle it's much better bars don't bounce around like they did. But now at 11 / 1200 rpm crazy vibration.  When riding there's vibration felt.

I'm thinking the motor isn't sitting correctly??

Any suggestions I might try or should  do are welcome.   Cheers

Left is Drag Specialties,..right is HD

Leave everything just snug (not tightened at all) and go for a ride.  Then tighten it up.  You'll likely fix your problem  .

"Your salesman is an idiot."   

Say it ain't so!   

                        Sorted out!!

         I tried something I saw on YouTube  by GlidePro Motor Mount Install

     He says to leave the mount fixings lose then go for a ride that will let the motor find it's  place to settle,  then tighten the to side bolts of the mount and the centre one  only snug it up so you can still move it back and forth,  job done.

      That's what I did and the issue is solved it's back too smooth riding. 

Hang in there Brother !!! Praying for you too have a full recovery !!!!

Dante

I read (online) that Jim's recovery was being done inside a well padded Bushtec trailer.