As requested here is some detail pics of the install. I don't show all of the locations but you'll get the idea. The lights are attached with VHB double sided tape. This is the same tape used by body shops to hold trim on cars. I brought the leads from the wires together under the tank and used heat shrink to put them all together the combined harness runs back under the frame alone the gas tank vent line, then throught the frame under the seat. I used an aux power connector and connected the fuse to the switched output. That way I can turn them on and off via the aux switch.
Hope this all helps someone, its nice to give back something to this site as its been great to me [smiley=laugh.gif]
Enjoy