Best plug & play HID set up for a RGU?

[Puzzled]

I just installed yet another set of lights in my work and this time I tried the 35 watt HIDs. Very nice so far. A little tough to explain the light output however it is different/brighter. 

[Midnight Rider]

Here is a link to an install from the site.

http://www.cvoharley.com/smf/index.php?topic=28425.0

Thanks, Mike...I had seen that thread a long while back and forgotten about it.  If you guys have had good service with the Xenon kit, there's no sense spending extra money for no good reason.

[petewerner]

Rio,
What about the LED's from HoleShot?

[Rio]

Rio,
What about the LED's from HoleShot?

It's really hard to tell from a picture.  On a CVO, I think it's important to have a factory fit or look.  The other picture of that brown bike had a factory finished look.  I called him and he doesn't have the time or interest in fabricating a the bracket and modifying the front bezel for the HD LED lights.  He said the way the can is set up, it's really difficult to rig a bracket that will hold the two lamps securely.  Holeshots look good, but I don't care for the blue base showing on the lights or the idea of a dimmer switch.  I would have to see some really good close up photos and maybe some member satisfaction.  I may consider HID's if I can figure out the LED's?

[petewerner]

Yeah I understand, I don't want anything less than perfect either. I have expressed to Big Jim that the issues u bring up and others for this to work. I know I will have one to look at next week and if it looks good enough, I will install it and take photos. As for the adjustment knob, I plan on setting it slightly lower than the full blast for my low beam and then attach it witha zip tie inside. Why would u mess with it anyway once u get it set. I will be to get to it from the front by removing the headlight cover if needed.
I will let you know.