I'll post up more pictures later....
I purchased the kit from LSHD1 for the detachable tour pack
53246-09A KIT, TOUR-PAK DETACH, FLHTC $459.00
Start with pulling the Maxi fuse
If you take the liner out of your tour pack you will see a bunch of wires. The tour pack lock, tour pack lights, running lights, CB antenna and radio antenna all need to be disconnected. CB and AM/FM antenna unscrew from the back of tour pack. All other wiring has quick disconnects built in, pull all these wires out of the tour pack holes by removing the grommets.
Remove seat and if you pull the wires on the tour pack speakers you will find a quick disconnect on each side, disconnect these as well. Now you will have two sets of wires one on each side. You can now remove the four bolts holding the tour pack on and remove the tour pack. Now follow the instructions that come with the detach kit and it's pretty straight forward on removing and installing the detach kit.
Pull off both chrome rail covers and you will see the four bolts holding the rack on, two per side. At this point, I undid three of the four bolts holding the amp on as it make it easier to remove with the rack off. Once you have the rack off you can remove the last amp bolt and let the amp hang on the right side. I did not disconnect the amp during the process.
Now follow the included instructions on installing the detach kit and that part is done. I marked all the wires going into the tourpack so I would remember where to reconnect. I then bundled the wires and put them all on top of the ECM module. I decided at this time to just put the amp in the right saddlebag. I know there are other options, but maybe later. I did have to take my dremmel and grind down a 1/4" notch into the saddle bag, right behind the front attach point to allow the cable to sit there without being pinched.
Challenge 1 - the fender fillers will not allow you to use the included am/fm antenna relocation kit. If you want to use the relocation bracket you will need to loose the fender fillers. I went with a hidden antenna inside the fairing.
This project was not nearly as bad as I thought it was going to be. Only took a few hours in the garage and anyone can do it.
Jeff