www.CVOHARLEY.com

Custom Vehicle Discussions => Screamin' Eagle® Road Glide® => Topic started by: ..Hawk on April 29, 2010, 09:01:32 PM

Title: Mediallions for Road Glides
Post by: ..Hawk on April 29, 2010, 09:01:32 PM

Looking for suggestions to cover up the indent on the rear fender.  Installed the curved Kuryakyn Licesen Plate Holder.  I've seen some examples on this site.

Second concern is attaching them.  Glue, tape or bolt on??  I want to be careful should I want to change the mediallion, or that may just not be possible.

Please provide some of your experiences, thanks in advance.

Hawk

Title: Re: Mediallions for Road Glides
Post by: Blazo on April 30, 2010, 01:00:28 AM

I used one of these, skull side out, stuck it on with double sided tape, still holding fine after 8k miles...
http://cgi.ebay.com/HARLEY-DAVIDSON-PLATE-WILLIE-G-SKULL-COIN-60997-D-907-/360254723547?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item53e0dad5db#ht_6039wt_940.

Title: Re: Mediallions for Road Glides
Post by: ..Hawk on April 30, 2010, 09:05:22 AM

Thanks Blazo.

Title: Re: Mediallions for Road Glides
Post by: skippy on April 30, 2010, 09:51:40 PM

I used a chrome mediallion with a black bar & shield in the center it in the big wish book from HD..... it about the size of a fifty cent piece....

Title: Re: Mediallions for Road Glides
Post by: jettjocky on May 03, 2010, 11:05:20 AM

FYI, prior to putting anything on the bike, I just cut a clear pc. of vinly on & then place the item on it,  :2vrolijk_21: