www.CVOHARLEY.com

CVO Technical => Intake/Exhaust/ECM => Topic started by: bubtrauma on June 16, 2019, 12:45:06 PM

Title: Power vision
Post by: bubtrauma on June 16, 2019, 12:45:06 PM

Hi guys,
I have a powervision and I seem to have lost two screws that the mounting bracket bolts to but can't seem to find the right thread pitch. I measured them and seem to need 36 pitch?

Any comments would be appreciated.

Title: Re: Power vision
Post by: IA17RGU on June 16, 2019, 02:40:42 PM

Best I could say is take one out and go to Lowe’s?  Fastenal?


Sent from my iPhone using Tapatalk

Title: Re: Power vision
Post by: Unbalanced on June 16, 2019, 06:50:11 PM

Have you called DynoJet customer service?

You might also try Daytona Nut and Bolt as another source

http://www.daytonabolt.com/index.html

Title: Re: Power vision
Post by: vtwinjim on June 16, 2019, 11:51:26 PM

If your talking about the u shaped bracket, mine seems to be 10-32 or .190-32
But I was able to insert a 5mm x .8mm thread pitch metric screw
10-32 will typically fit into 5mm x .8mm thread pitch so it could be metric
.8mm pitch = 31.75 TPI
5mm = .197 inch