www.CVOHARLEY.com
Custom Vehicle Discussions => Screamin’ Eagle® Ultra Classic® Electra Glide® => Topic started by: electraglideclyde on September 30, 2018, 05:04:39 PM
-
When I removed the stock dual beam headlight to replace it with a LED, I also removed the wiring harness that splits the headlight connector to connect to the dual beam. Now I can't find the splitter. I've been to several HD shops and no one has a clue. Anybody have a parts supplement for a 06 CUSE that can give me a part number for that wiring harness ?
-
I have the book at the shop, I'll check tomorrow for you if nobody has it sooner.
-
Have you tried looking for it on Ronnies OEM Parts Finder (http://partsfinder.onlinemicrofiche.com/ronnies/partsfinder.htm)? Not sure what part you're speaking of or I would try to find it for you.
:pumpkin:
Ride Safe,
Fired00d
:fireman:
-
The way I read this is that you need the xtra harness they have for controlling the garage door opener. If not someone will find what you need.
Part number is 70174-06 for the complete harness.
-
The way I read this is that you need the xtra harness they have for controlling the garage door opener. If not someone will find what you need.
Part number is 70174-06 for the complete harness.
I believe #3 is the correct part. WOW, $121.99 for a couple of connectors and some wire. I guess I'll have to try and make one.
Thanks
-
There is another part number listed but not illustrated that may be just the smaller Y-harness to accommodate the dual bulbs. See if your dealer can look this one up and see if it's what you need. It's about $34, versus approximately $143 for the harness with the garage door opener connections.
70319-04 WIRING HARNESS HALOGEN BULB INTERCONNECT
Jerry
-
Thanks Jerry. I will try that one.
-
Has there been changes accessing Ronnies OEM Parts Finder?
I have been using it for some time and now the link takes me to a Dead End Page after I select the link to go to HD parts finder.
-
Go to a good local auto parts store. Replacement pigtails for various different headlights will be a stocked item. If they don't have a Y connector they'll have enough pieces you can make one.
-
Has there been changes accessing Ronnies OEM Parts Finder?
I have been using it for some time and now the link takes me to a Dead End Page after I select the link to go to HD parts finder.
This is the address I have set up in my shortcut for Ronnies, still works as of this am. I have noticed in recent weeks the site is often slow to navigate.
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
Jerry
-
This is the address I have set up in my shortcut for Ronnies, still works as of this am. I have noticed in recent weeks the site is often slow to navigate.
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
Jerry
This one works okay, thanks Jerry.