Topic: 07 SEUC Rear cylinder weeping (Read 5130 times)

grc · « **Reply #15 on:** October 04, 2007, 08:37:07 AM »

Quote from: skreminegul07 on October 04, 2007, 08:17:49 AM

.003 is the manufacturing tolerance, ~~.0012~~ .012 is the max service wear limit measured near the flywheel.

skreminegul07 · « **Reply #16 on:** October 04, 2007, 08:53:21 AM »

Thanks, I've typed it that way before.

rogerkmac · « **Reply #17 on:** October 20, 2007, 08:25:08 PM »

Update.....After waiting for 2 weeks all parts finally arrived to take care of the rear cylinder leak. In addition, I decided that while the bike was in I would have the iso drive system installed. While it's still too early to know if I will remain leak free...I have to say wow to the iso drive addition...talk about smoothing out the ride and it virtually eliminated the 5th gear whining.

So I have my fingers and toes crossed about the leak.....but I sure will enjoy the ride thanks to the iso drive.

rogerkmac · « **Reply #18 on:** October 20, 2007, 08:29:23 PM »

Almost forgot the best news....while everything was in pieces I had them check the crankcase runout...it was .004. While it cost me a little money to check it was definitely worth the piece of mind.

skreminegul07 · « **Reply #19 on:** October 20, 2007, 11:58:58 PM »

Quote from: rogerkmac on October 20, 2007, 08:29:23 PM

Almost forgot the best news....while everything was in pieces I had them check the crankcase runout...it was .004. While it cost me a little money to check it was definitely worth the piece of mind.

Priceless

Author Topic: 07 SEUC Rear cylinder weeping (Read 5130 times)

grc

Re: 07 SEUC Rear cylinder weeping

skreminegul07

Re: 07 SEUC Rear cylinder weeping

rogerkmac

Re: 07 SEUC Rear cylinder weeping

rogerkmac

Re: 07 SEUC Rear cylinder weeping

skreminegul07

Re: 07 SEUC Rear cylinder weeping