What model bike? If a batwing model, how did you refill without dissembling?
SEEG batwing, removed outer fairing and inner fairing cap (switches) to gain access to the fork tube caps, drained the forks with the drain plugs, filled with a measured amount of oil using a small funnel and piece of clear tubing. That isn't what I call disassembling. Disassembling is when you remove the fairing, remove the fender, remove the wheel, remove the forks from the steering head brackets, place the fork tubes in a vise with special protective holder, remove the springs and damping devices, separate the sliders from the fork tubes, remove the seals, etc. Then you clean all the pieces, replace the seals, reinstall all the pieces, fill the tubes and install them to the bike, etc. That will take some time, especially for those without the full shop setup with a lift.
Jerry