www.CVOHARLEY.com
CVO Technical => Wheels/Tires/Suspension/Brakes => Topic started by: roadrunner on January 05, 2020, 05:04:47 PM
-
Did a brake fluid change and rear brake is spongy.
I didn't introduce any air into the system, no abs codes, and abs light goes out when in gear.
I did drive the bike and do some hard braking to activate the abs.
Would i need the dealer to run the scan program for the abs or try to bleed again?
Cheers again!
Sent from my SM-N950U using Tapatalk
-
Sounds like the old elusive air bubble. :confused5:
-
I was told by dealer that they have to use their scanner to bleed the brakes... not sure why, thinking to run the linked brake motor to remove the air :nixweiss: they wanted 200. bucks to flush brakes and clutch fluid
-
Dealer can purge for lack of a better word the abs module with the scanner, getting all the fluid out.
We can do a flush, ride the bike, brake to activate the abs, then flush again.
The snapon equix (sp) scanner can initiate a brake flush also. Assuming they have the hd software installed.
I'll give it another flush when my fluid syringe pump comes in.
Thanks
Sent from my SM-N950U using Tapatalk