www.CVOHARLEY.com

CVO Social => Other Topics => Topic started by: Eddie Haskell on January 20, 2018, 11:07:58 AM

Title: Tool Question
Post by: Eddie Haskell on January 20, 2018, 11:07:58 AM

 Does anybody have a link to or know the name of the tool that is required to remove the coolant lines from the heads on the water cooled HD's?
 Thanks in advance

Title: Re: Tool Question
Post by: hd-dude on January 20, 2018, 11:18:42 AM

To my knowledge there isn't a specific tool. Just use a small pick to get the cir-clip out of the fitting then the line pulls out.

Title: Re: Tool Question
Post by: bakon on January 20, 2018, 05:24:52 PM

Screwdriver...small. Or a pick.   Just pay attention to how they are in there so you can get it back in. Used a reverse plier, like a ring expander to open slightly when inserting the two legs into two holes and pushing them around to the outside. The roundness of the fitting wants to just block the legs. And the third slit in the fitting is for the center.  Just study it when you hook it out.