Alwesome bike , I need the LED like that , where did you got them and how to put them in ?
Thanks
The blue LED's are from Custom Dynamics. CD LED's are pricey, but pretty nice. I was told the remote had a dimmer, but it doesn't (and that didn't set well with me). They are very bright, and a dimmer function would have been nice instead of all the crazy blinking functions that came on the remote. If I had to do it over, I would have left them off and spent my money on different mods, as I rarely use them.
Putting them on was a day long adventure and taught me a lot about the bike. I have them located under both the front of the fairing and the tour pak, at the bottom of both saddlebags and the tranny, along both sides of the gas tank (which has to be removed to do that properly), behind the horn bell and the air breather case, and behind the engine under the seat. Use lacquer thinner or 3M promoter to prep the area before you stick them to the bike, otherwise they'll fall off. And absolutely don't run the wires anywhere they could get rubbed, crushed, or cut. Solder the wires together whenever possible and don't use wire nuts. Any wiring has to be rock solid on the bike or you'll develop a short in no time.
I drew up my own schematic so I knew how many lights I wanted at each location (these LED strips can be cut into multiples of 3 lights per strip and individually hooked up, then I checked them carefully for fit and placement before attaching them. Also check each one to a 12v battery several times both before and after installation to make sure they work properly. Wire direct to the battery and you won't have any issues. I have one remote in my tour pak and another velcro'd to the bike so I can reach it while driving.
Hope this helps, and thanks for the comments!