CVO Technical > EVO
EVO Combustion Chamber mods
(1/1)
MCE:
Has anyone tried moving the chamber wall away from the Intake valve on that "flat" portion?
Any EVO experts care to weigh in on this?
johnsachs:
Marked improvement depends on valve size. I always move a small amount of wall on the exhaust side, as the wall is closest there. ;)
John
MCE:
--- Quote from: johnsachs on June 13, 2018, 06:52:58 PM ---Marked improvement depends on valve size. I always move a small amount of wall on the exhaust side, as the wall is closest there. ;)
John
--- End quote ---
Thanks John, The intake was pretty close at 1.9, I took a little out but I didn't see any
gains. (I probably didn't take enough out) Just curious b/c they flowed a little less than
I expected (like 10 less).
prodrag1320:
I also un shroud the wall on EVO heads,especialy when bigger valves are used
Navigation
[0] Message Index
Go to full version