www.CVOHARLEY.com

Custom Vehicle Discussions => Screamin’ Eagle® Dyna® Fat Bob => Topic started by: hdnik on March 24, 2012, 10:03:28 PM

Title: FXDFSE rear plate frame
Post by: hdnik on March 24, 2012, 10:03:28 PM

OK this may be a dumb question, but do the USA CVO fat bob with bobtail fender have any problem mounting your plate with a HD frame?

Here in Canada our plate holes aren't the same but we just redrill and go. The issue is the frame won't fit under the reflector. Do domestic bikes have a different mounting bracket than us?

Title: Re: FXDFSE rear plate frame
Post by: hdnik on March 24, 2012, 10:07:41 PM

Here is a picture of our mount. Is the USA one the same. If so what solutions for a plate frame is there?

Title: Re: FXDFSE rear plate frame
Post by: zrx4me on March 25, 2012, 02:26:57 PM

anybody know what pipe that is?

Title: Re: FXDFSE rear plate frame
Post by: cvo1717 on March 25, 2012, 02:48:06 PM

We have the same bracket from what i can see.Its pretty flimsy IMHO

Title: Re: FXDFSE rear plate frame
Post by: cvo1717 on March 25, 2012, 02:49:38 PM

Pipe looks like rinehaert 2;1

Title: Re: FXDFSE rear plate frame
Post by: hdnik on March 25, 2012, 05:29:18 PM

Quote from: zrx4me on March 25, 2012, 02:26:57 PM

anybody know what pipe that is?

cvo1717 is correct

Title: Re: FXDFSE rear plate frame
Post by: hdnik on March 25, 2012, 08:24:32 PM

That being case you all must have the same issue adding a plate frame. Any suggestions?

Title: Re: FXDFSE rear plate frame
Post by: cvo1717 on March 26, 2012, 07:19:18 PM

I did not put a plate frame on just mounted the plate looks ok 

Title: Re: FXDFSE rear plate frame
Post by: ALRG8TOR on April 08, 2012, 04:35:11 PM

Mine was a very tight fit, no drilling needed, but it took a few minutes to make it work.

Good luck!