I have not posted on this yet because I am waiting on the MOCO. When Punkin's motor was torn down to do the timken conversion and bore the cases for future upgrades it was found that my fly wheel assembly was out of true. .008 on one side and .004 on the other. As a result of this the pinion shaft is worn. Zippers will not do a reassembly on the motor till this is straightened out. The bike was still under the MOCO's warranty(not extended which I don't have). I am trying to get the factory to cover the flywheel assembly under warranty, which they should. The motor had a bad vibration in the past so I now know where it came from (I had a good idea).
So right now I am still without Punkin. There are a few ways to go on this. 1 the factory will warrant the assembly,2 order a Jim's SE 103 assembly or 3 repair my original set.
No matter which way it turns out that I go number 2 is my last choice. Number 1 is my first choice. No matter which way I go I will be sending the assembly to Flordia to be retrued and welded. That way it will never move again till I want it too.
I hope to have some anwsers this week.
Be Safe
THE DAWG