Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Ironhorse]

I cleared ALL the offsets, loaded the MAP, initialized, and it fired right up. I ran it up to 289 degrees and let it set the IAC. The bike runs great except for one thing. When I come to a stop, the rpms drop about 100 below the set idle, and then come right back up to where they should be. I read the manual and there is nothing to address this in the trouble shooting section.

Any ideas?

Mark

[Deuce Bigelow]

clear the offsets again and do not do the auto IAC, just let the ECM autotune the idle..
just let it idle up to 289* without the auto IAC, it may help.....

[Ironhorse]

clear the offsets again and do not do the auto IAC, just let the ECM autotune the idle..
just let it idle up to 289* without the auto IAC, it may help.....

I'm sorry I must have written it wrong, but that's what I did. I let the IAC set it self, I DID NOT, use the IAC Auto feature.

Mark

[Deuce Bigelow]

I'm sorry I must have written it wrong, but that's what I did. I let the IAC set it self, I DID NOT, use the IAC Auto feature.

Mark

AHhhhh.....

then give it some miles to autotune itself.
should be ok..

I haven't really noticed if mine does that or not...lol

[Ironhorse]

AHhhhh.....

then give it some miles to autotune itself.
should be ok..

I haven't really noticed if mine does that or not...lol

Mine only seems to do it when cold. Once the engine is fully warmed up it stops.

Mark