www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Bearings  (Read 2113 times)

0 Members and 1 Guest are viewing this topic.

mfgreen

  • Guest
Bearings
« on: February 22, 2005, 10:03:55 AM »
Does anybody know the official reasons for the change made in bearings from the Timken bearings to the current set-up?  Was it a matter of a cheaper cost? More profitably? Easier service?
Logged

PCC

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 203
Re: Bearings
« Reply #1 on: February 22, 2005, 11:21:44 AM »
I'm not sure of the rational, but I do know it is the left side bearing only that was changed.
Logged

the O`Fender

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 751
  • On the Dragon
Re: Bearings
« Reply #2 on: February 22, 2005, 01:03:33 PM »
Cheaper to make, less time to install, bigger profit margins, a no brain decision for management/stock holders [smiley=xyxthumbs.gif]
Logged
2020 Scorched Orange Limited
 

Page created in 0.117 seconds with 22 queries.