www.CVOHARLEY.com

CVO Technical => Electronic Toys and Gadgets => Topic started by: Stewie_FL on January 01, 2020, 08:33:09 AM

Title: Saddlebag run/brake/turn lamps
Post by: Stewie_FL on January 01, 2020, 08:33:09 AM

Just bought a set of the saddlebag lights for my 2020 CVO limited. Haven't installed them yet.

The catalog and web site both say PN 67800604 fits 2016 and later FLHTKSE (CVO). However, the label on the box says except FLHTKSE.

In the box the module/harness PN is 69200779A yet in the online instructions it says PN 69200949A is the module/harness for the FLHTKSE .

If you look up the tour pak conversion, it says you need buy separate the 69200949A module/harness for a CVO.

I'm so confused. Anyone put just the saddlebag lights on a newer CVO? I really don't want to take the 70 mile drive back to the dealer to figure it out.

Thanks.

Title: Re: Saddlebag run/brake/turn lamps
Post by: fdny136 on January 01, 2020, 10:51:44 AM

I Did this recently on my 2019 .I do not remember exactly what I bought but I do kno the 779a module is correct and you do not need anything else

Title: Re: Saddlebag run/brake/turn lamps
Post by: 17 StreetGlide CVO on January 02, 2020, 05:32:53 AM

I put the Custom Dynamic sequential low profile BAGZ saddlebag lights   
on my 17 Streat Glide CVO. Did not need anything else, lights plugged right in. They work great.

Title: Re: Saddlebag run/brake/turn lamps
Post by: Stewie_FL on January 02, 2020, 07:38:58 AM

Thanks for the replies. Think I was just over thinking it. The kit works fine as is. Sometimes more information is not good I guess.