Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[hd-dude]

FINALLY getting the pods installed onto my own bike. I had them painted to match the Dark Candy Cherry inner fairing. They disassemble very easy for painting with only two screws. The kit comes complete with Tweeters, x-overs, drilling templates and instructions. Here is a pic of the kit once assembled into the painted pods.

[hd-dude]

Here are the template in position to mark where the holes are drilled for the pods

[hd-dude]

1st drill an 1/16" pilot hole on both sides, Drill from the inside out....VERY SLOWLY so you do not pull the paint on the outside.

[hd-dude]

Then from the front enlarge each hole to 1/4"

[hd-dude]

The pods have a full rubber gasket on the back to seal the unit to the fairing. Here they are mounted in place

[hd-dude]

They are help in with a single screw through the upper hole that was drilled into the fairing. the lower hole is for the wires.

[hd-dude]

The x-overs come pre-terminated. One set goes to the tweeter and the other side has male female connectors to connect right to the factory speakers leads.

[hd-dude]

In my application I am using the Hawg-wired amp so i cut the connectors off and connected them directly to the amp outputs in parallel with the Fairing speakers.

[hd-dude]

Next mount the x-overs and tye up the wires.

[reo]

You still have me on your list right Jim?

[hd-dude]

All closed up and back together.

[hd-dude]

So...how do they sound? CRISP, CLEAN, and very bright.   They are spaced far apart and angled pretty much right at your head. A very nice addition

[hd-dude]

You still have me on your list right Jim?

I have them in stock. Give me a call.

[reo]

thanks Jim, I'll call you this weekend

[49445CVO]

Thanks Jim. Once again nice job.   

Topper

BTW I am so glad you are not by me for I think I would find myself at your shop daily.