CVO Technical > Wheels/Tires/Suspension/Brakes
raer spindle torque setting
(1/1)
johnmowcop:
Bit of advice please.
2011 Road Glide Ultra CVO
The rear axle torque setting is stated as 95 to 105 ft lbs.
This is using the torque adaptor, if I do not have one of them but apply the torque wrench direct onto a socket on the axle nut, does the same torque setting apply.
Regards
JohnT
cvosjoe:
--- Quote from: johnmowcop on January 14, 2020, 05:10:58 PM ---Bit of advice please.
2011 Road Glide Ultra CVO
The rear axle torque setting is stated as 95 to 105 ft lbs.
This is using the torque adaptor, if I do not have one of them but apply the torque wrench direct onto a socket on the axle nut, does the same torque setting apply.
Regards
JohnT
--- End quote ---
Yes
Sent from my SM-N975U using Tapatalk
SIKBIRD:
That is correct. Torque adapters do not change the torque of the wrench when used at 90 degrees to the wrench. Check out this video.
Navigation
[0] Message Index
Go to full version