CVO Technical > Wheels/Tires/Suspension/Brakes

raer spindle torque setting

(1/1)

johnmowcop:
Bit of advice please.
2011 Road Glide Ultra CVO
The rear axle torque setting is stated as 95 to 105 ft lbs.
This is using the torque adaptor, if I do not have one of them but apply the torque wrench direct onto a socket on the axle nut, does the same torque setting apply.
Regards
JohnT

cvosjoe:



--- Quote from: johnmowcop on January 14, 2020, 05:10:58 PM ---Bit of advice please.
2011 Road Glide Ultra CVO
The rear axle torque setting is stated as 95 to 105 ft lbs.
This is using the torque adaptor, if I do not have one of them but apply the torque wrench direct onto a socket on the axle nut, does the same torque setting apply.
Regards
JohnT

--- End quote ---

Yes

Sent from my SM-N975U using Tapatalk

SIKBIRD:
That is correct. Torque adapters do not change the torque of the wrench when used at 90 degrees to the wrench. Check out this video.

Navigation

[0] Message Index