www.CVOHARLEY.com
Custom Vehicle Discussions => CVO™ Road Glide Ultra® => Topic started by: 610hog on October 19, 2015, 08:04:14 PM
-
Does anyone have the wiring diagram for the rear fender lights. I'm looking to splice in single LED to light up my Licence plate below the light bar. Doing the Detachable Tour Pak, buying the parts separately and relocating Licence below.
-
Don't splice your harness, go back to the connector in front of the tourpak where the rear harness plugs in and tap there. Pull the pin you want and do a solder-in connection there. I just never can imagine a reason to splice a can-bus harness.
-
Thanks.
-
Even easier than that , open your tail light, use the empty three prong connector in the top left corner. Use Pin one and pin three. If you use a kury led plate it will include the correct connector.
-
Yes that sounds a lot easier. I really appreciate the input. I will post pics when done.
-
FLSTFI Dave left detailed directions: Plate relocation and lighting for frame (http://www.cvoharley.com/smf/index.php?topic=98618.msg1279313#msg1279313)
-
FLSTFI Dave left detailed directions: Plate relocation and lighting for frame (http://www.cvoharley.com/smf/index.php?topic=98618.msg1279313#msg1279313)
Yep, thanks for posting the link Greg.
:)
-
Even easier than that , open your tail light, use the empty three prong connector in the top left corner. Use Pin one and pin three. If you use a kury led plate it will include the correct connector.
I like the way that bracket goes below the taillight and doesn't cover the CVO badge... could you supply the P/N for it? Thanks in advance.
Joe B.
-
x2