www.CVOHARLEY.com
CVO Technical => General CVO discussion => Topic started by: GregMan241 on November 07, 2023, 10:53:45 AM
-
Hi guys,
I have a 2006 flstfse2 and need to replace rear turn bulb......
The smoked lens cover (unlike the one on the front) does not have a slot to insert a screw driver to remove.
It spins with effort but does not unthread.
Any thoughts? Don't want to turn this small job into a repair lol!
Thanks and cheers,
Greg.
2008 flhrse4
2006 flstfse2
-
It's a tension fit. Just be brave and pop it off.
-
LOL..... thanks for confirming it wasn't some other form of fastening.....
I got it off.... used a small putty knife with a very fine metal blade, was able to carefully insert and pry and didn't f things up....
thanks again and cheers,
Greg.
-
Greg,
Just in case you did not know, the "slot" in the front signals is also to allow water / condensation to drain so make sure it is pointed down. :2vrolijk_21:
Greg