Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: EVO Combustion Chamber mods  (Read 3636 times)

0 Members and 1 Guest are viewing this topic.

MCE

  • Guest
EVO Combustion Chamber mods
« on: June 13, 2018, 02:16:43 PM »

Has anyone tried moving the chamber wall away from the Intake valve on that "flat" portion?

Any EVO experts care to weigh in on this?
Logged

johnsachs

  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 747
Re: EVO Combustion Chamber mods
« Reply #1 on: June 13, 2018, 06:52:58 PM »

Marked improvement depends on valve size. I always move a small amount of wall on the exhaust side, as the wall is closest there.  ;)
John
Logged

MCE

  • Guest
Re: EVO Combustion Chamber mods
« Reply #2 on: June 13, 2018, 07:21:46 PM »

Marked improvement depends on valve size. I always move a small amount of wall on the exhaust side, as the wall is closest there.  ;)
John

Thanks John, The intake was pretty close at 1.9, I took a little out but I didn't see any
gains. (I probably didn't take enough out) Just curious b/c they flowed a little less than
I expected (like 10 less).
Logged

prodrag1320

  • AMRA & AHDRA P/D record holder
  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 917
Re: EVO Combustion Chamber mods
« Reply #3 on: June 21, 2018, 06:54:36 AM »

I also un shroud the wall on EVO heads,especialy when bigger valves are used
 

Page created in 0.123 seconds with 25 queries.