Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ultrarider123]

LED install

I see you also installed the "spider man tires"....so sticky they will hang on ceilings....

Nice mood lighting on the scooter, by the way.

Image adjusted:

[michaelokielee@yahoo.com]

Tightened up some loose bolts I found causing an oil leak, where the exhaust bracket on lower right side of engine bolts on.  Got her all cleaned up to ride to Thunder Beach on Wednesday!!

[Twolanerider]

Tightened up some loose bolts I found causing an oil leak, where the exhaust bracket on lower right side of engine bolts on.  Got her all cleaned up to ride to Thunder Beach on Wednesday!!

Exhaust bracket bolts have through holes to oil? 

[Bav]

Exhaust bracket bolts have through holes to oil? 

I thought they were blind?

[Twolanerider]

I thought they were blind?

They are.  Can't get an oil leak from the holes that mount the exhaust brackets.  Can get leaks forward of that that run or blow back and collect there though.

[OBB]

Went for a ride this morning....about 175 miles.  Rode Ca 94.  Click on this link and scroll about half way down the page....


  http://www.motofoto.us/Motorcycles/Hwy-94/04242016/









Then I rode over to Coronado.  Hooked up with Miguel, his aunt & niece that are in town visiting.....we checked out all the cars at the car show....




Miguel's Street Glide doesn't have a back seat so I gave Gloria, his cousin, her first ride on a Harley....her first ride on a motorcycle!  We rode down the Silver Strand and then over the Coronado bridge and back.  Stopped at Chicano Park to take this pic of her with the mural....

flip flops on a bike JC? Dunno about that SoCal lifestyle.

[DCFIREMANN]

Changed the injectors in my 14 SE Limited then smart tuned it.

Be Safe

THE DAWG

[michaelokielee@yahoo.com]

Exhaust bracket bolts have through holes to oil? 

THEY ARE THE EXHAUST BRACKET HANGER BOLTS THAT GO THRU THE EXHAUST HANGER BRACKET AND PICK UP THE TWO BOTTOM BOLT HOLES IN THE TRANSMISSION ON THE RIGHT HAND SIDE

[dayne66]

Finally got around to putting in the proper new garage door remote....wired in to an odometer reset push button switch in one of the switch blanks.

[Royalroadie]

Did you go internal with the wiring?

If you mean pulling the wire thru the inside of the bars, No.   The power wires are to big to do it that way it splits into about 4 different wire groups.  Power, intercom, headphone and command mic.  I just put them on the bottom of the handlebars and went in thru the left side handle bar grommet. 

[OBB]

If you mean pulling the wire thru the inside of the bars, No.   The power wires are to big to do it that way it splits into about 4 different wire groups.  Power, intercom, headphone and command mic.  I just put them on the bottom of the handlebars and went in thru the left side handle bar grommet. 

Don't know what bike you have but when I changed the bars on my '11 SERGU I had, I pulled the 660 wires out of the stock bars and fought like hell to get them through the new ones. I did manage to get it done though.

[HUBBARD]

Maybelle looks better with a Black Motor........to me, anyway.  Later--HUBBARD

[HUBBARD]

Chrome Inner Primary--hard to get past "Old School" ways!  Later--HUBBARD

[HUBBARD]

Not as much difference in the Borzilla, vs. the Fat-Cat, as in a few years back.  Later--HUBBARD 

[HUBBARD]

Got rid of that "Wind Splitter" Windshield, too.  It was like looking through a Carnival mirror......to me, anyway.  Put the original back on.     Later--HUBBARD