CVO Technical > Drive Train

slipper clutch

<< < (2/3) > >>

geezerglide:
Tony,

No mods required to clutch. My bike has the HD Six Speed, so it has the SE Diaphgram. And it is a 15 minute bolt in job with no special tolls required for TC. EVO and Sportster more worl.

I am not sure what Clutch Pack are in the SE CVO Bikes, however I assume they are stock HD Clutch Packs.

Again log on the the AIM or HIPPO sites and installtion procedures are included.

geezerglide

geezerglide:
103tHunDer,

I will try and post to the Dyno Run Post.

Thanks again,

geezerglide

Tony - www.1700cc.co.uk:

--- Quote ---No mods required to clutch.
--- End quote ---


Geezer,

So do I just get my dealer to shove this thing on and my new SEEG will be able to handle the 120 BHP & 120 TQ that I intend to throw at it?

geezerglide:
Tony,

I would advise you to email HIPPO at HippoVPC@gmail.com the information of your engine build, HP & TQ, he will review and suggest a VPC Unit more than likely a VP 92T and you can purchase direct from him, as he probably has them in stock in Phoenix, or, if their is a dealer in the UK you can get from him.

geezerglide

Tony - www.1700cc.co.uk:

--- Quote ---In the May issue of Hot Bike
--- End quote ---


Geezer,

I do have the May issue of Hot Bike but didn't spot the article. Can you help point me in the right direction to read some more about it.

Thanks
Tony

Navigation

[0] Message Index

[#] Next page

[*] Previous page