CVO Technical > Drive Train

anyone have a clutch issue?

<< < (6/6)

bbowler:
    I rode it another 200 miles and so far i say its good. But for sure you better have the clutch stck to your grip all the way in because if its a 1/16 of an inch out it will start to grab. I kinda liked the slight bit of play in the cable clutches better.

hd-dude:
The issue here is air in the hydraulic clutch system. Bleed it properly and the issues will be resolved unless there is an issue with the master or slave cylinder, which is unlikely.

WFP:

--- Quote from: hd-dude on October 20, 2009, 09:48:06 PM ---The issue here is air in the hydraulic clutch system. Bleed it properly and the issues will be resolved unless there is an issue with the master or slave cylinder, which is unlikely.

--- End quote ---

Thanks Jim, I Bled mine at the actuator and it did improve the issue and all creep stopped.  I have to admit, my 1/4" wrench could not turn the valve so I had to use a socket after removing the hose...and then loosened it too far and it started to release fluid before I was ready.  Doh!

/Bill

Navigation

[0] Message Index

[*] Previous page