www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: TC case bolt  (Read 1163 times)

0 Members and 1 Guest are viewing this topic.

hrdtail78

  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 762
TC case bolt
« on: January 31, 2018, 06:33:56 PM »
Is part number 1090A the only longer bolt that HD offers or is there another one?  This is for the top center bolt used with bored cases.
Logged

Ohio HD

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 122
Re: TC case bolt
« Reply #1 on: January 31, 2018, 07:13:50 PM »
How about S&S 50-0119 for 4.000" bore, S&S 50-0327 for 4.125" bore, and uses S&S 50-8063-S sealed washers.
Logged
2009 Ultra Classic ~ Bone Stock 96 inches
2008 Street Glide ~ Bone Stock 117 inches

hrdtail78

  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 762
Re: TC case bolt
« Reply #2 on: February 01, 2018, 11:30:06 AM »
Thanks Brian.  Those are through bolts and I am looking for a SE case.  I have thought about machining the right side case for a through bolt.  I don't know if there is an advantage to this.  I have to relieve the SE bolt to 1.9 for 4 1/8inch cylinders anyway.

Any thought on machining for through bolt anybody over just relieving the blind bolt?
Logged

Ohio HD

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 122
Re: TC case bolt
« Reply #3 on: February 01, 2018, 11:52:19 AM »
Ah, I see. I should have figured you would be using the S&S parts if it was a direct bolt up. 
Logged
2009 Ultra Classic ~ Bone Stock 96 inches
2008 Street Glide ~ Bone Stock 117 inches

wfolarry

  • Vendor
  • Newbie
  • *
  • Offline Offline
  • Posts: 49
Re: TC case bolt
« Reply #4 on: February 01, 2018, 01:31:56 PM »
You’re better off with the through bolt on bored cases IMO.
The S&S bolt kit comes with rubber coated washers for a leak free installation.
Logged
 

Page created in 0.113 seconds with 21 queries.