Custom Vehicle Discussions > Screamin’ Eagle® Softail® Springer®

Springer Risers

(1/1)

BIGMONEY:
Looking for the shortest risers for my o7. will the risers from a crossbones work? or really any other springer Harley work? thanks

gmeikle:
"Educated guess"...yes probably

I built a Crossbones front end into my 2008 CVO Springer and the component parts were often the same part number Crossbones V Springer

Slightly different rake on the Crossbones , but most all else the parts all worked. Had to make spacers for the axle as CVO Springer and Crossbones fenders differ.

I reused the CVO Springer headlamp, chrome risers and handlebars, alloy wheel, fender and fender mounting brackets. These were the "different" parts on the Crossbones.

I reckon the risers would fit/crossover. Assuming the handlebars are the same diameter , apologies I can't remember it was a few years back now.

hogdownunder:
Hi guys,

The Cross bones handle bar is 1", the CVO handle bar is 1 1/4", therefore they would not fit.   

DarkEagle:

--- Quote from: BIGMONEY on October 08, 2023, 08:56:24 AM ---Looking for the shortest risers for my o7. will the risers from a crossbones work? or really any other springer Harley work? thanks

--- End quote ---
The 2009 FXSTSSE3 riser stud is about an inch shorter than the 2007-2008’s.
I got the 2007-2008 riser studs to raise my 2009’s handlebars up a bit with no other mods, you could get the 2009 riser studs to lower yours but might have to watch clearance of the handlebars & handlebar mounted tach…
Sorry not responded sooner, don’t check this site as much, see diagram of the 2009 under HANDLEBAR, #9…
https://serviceinfo.harley-davidson.com/sip/content/document/view?id=1681729874893935931

Navigation

[0] Message Index