www.CVOHARLEY.com

CVO Technical => General CVO discussion => Topic started by: ultrafxr on October 20, 2021, 06:52:08 PM

Title: Sticky Throttle
Post by: ultrafxr on October 20, 2021, 06:52:08 PM

So I'm on the road on the way home from a week long trek.  Misting rain a bit the last few miles.  I pull in to the hotel and then have to move the bike and when I release the right hand grip the motor stays revved up.  Throttle did not snap back.  Shut it off and rolled the throttle.  It does snap back but not all the way.  So what's up?  Need a new twist grip sensor or is something binding due to the moisture?  This is on my 2020 Tri-Glide.  TIA for any advice.

Title: Re: Sticky Throttle
Post by: Phreakyz on October 21, 2021, 10:47:11 AM

Try loosening the screws on the covers and adjusting the positioning of the covers a little and then tighten back up while checking for any binding.   That worked for my '19.

Title: Re: Sticky Throttle
Post by: ultrafxr on October 24, 2021, 09:27:14 AM

Quote from: Phreakyz on October 21, 2021, 10:47:11 AM

Try loosening the screws on the covers and adjusting the positioning of the covers a little and then tighten back up while checking for any binding.   That worked for my '19.

Did and did. All good now. Thanks


Sent from my iPhone using Tapatalk