www.CVOHARLEY.com
Custom Vehicle Discussions => Screamin' EagleĀ® Road GlideĀ® => Topic started by: LC110 on June 04, 2014, 04:39:27 PM
-
Does anyone know if the stock sissy bar that comes on the 09 will work with this seat? Mustang 79538 Super Touring One-Piece Vintage Seat
-
It should, installation and size doesn't go past the mounting screw, so you should be good. My backrest fit when I had my Wide DayTripper installed.
-
the seats changed in 2007 2008 and 2009 so factor that into the equation
-
What I was worried about was the width. I have tried a few different seats and when I go to slide the sissy bar in, I would have to compress the sides of the seat in. It would then end up with the seat wearing against the bar. This is with the standard short bar/w 4 point mounting hardware 2009 SERG.
-
What I was worried about was the width. I have tried a few different seats and when I go to slide the sissy bar in, I would have to compress the sides of the seat in. It would then end up with the seat wearing against the bar. This is with the standard short bar/w 4 point mounting hardware 2009 SERG.
might be easier to remove sissy bar , install seat and then replace sissy bar
-
might be easier to remove sissy bar , install seat and then replace sissy bar
That is what I have been doing. No problems with my present seat. Just some of the aftermarket seats I have tried.
I just wanted to know if anyone has first hand experience using the Mustang 79538 Super Touring One-Piece Vintage Seat with the stock sissy bar.
-
Actually it's easier to put the sissy bar on first, then put the seat on.
My first seat on my SERG was the 2 pc Mustang seat- the original one before the Super Touring- the stock short backrest didn't rub the seat from what I recall.
-
Call Mustang, they probably know. Great seat though
-
Thanks, They were not sure. :nixweiss: