www.CVOHARLEY.com
CVO Technical => General CVO discussion => Topic started by: JONNIEROCK on May 03, 2021, 09:33:45 PM
-
I've got a 16 CVO SG. When I hold down the trigger switch (description in manual) to engage to accessory mode, seems like I always end up resetting one of the trip meters, which I use for oil changes and mileage. Anyone have a trick for operating this switch without resetting one of the meters? I done it, but it's a nano second between doing it right and not.
Thanks Jonnierock
-
I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.
-
I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.
Same here, if you I am in odometer display or miles till empty I can avoid a trip reset.
-
I would get caught in the dreaded reset when exiting aux mode, I found that while still in aux mode I cycle all the way through back to total mileage then exit it and all seems well since doing that.
-
When you're holding your button down wait for the gauge needles to jump then let go works for me
Sent from my SM-N975U using Tapatalk
-
Thanks for the help. Leaving on total mileage is the ticket. If it's on any trip mileage, i always seem to hold it down a nano second to long, thus resetting it.