Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]  All

Author Topic: Moto Lights on the Convertible?  (Read 5596 times)

0 Members and 1 Guest are viewing this topic.

Gamma742

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 265
    • CA


    • CVO1: 2010 FLSTSE Red
Re: Moto Lights on the Convertible?
« Reply #15 on: February 05, 2010, 09:44:28 PM »

Do you plan to mount the front turn signals to the bottom of the passing lamps?
Logged
2017 Road King
2010 Convertible

MikeV

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 325

    • CVO1: 2010 FLSTSE CVO Softail Convertible
Re: Moto Lights on the Convertible?
« Reply #16 on: February 06, 2010, 01:06:38 PM »

I went to a local custom shop and saw the motolights installed on a 03 SE Deuce. I was surprised that they were not quite as obtrusive as I thought. I was worried that they may look out of place on the ConV but they were not that bad. The real problem was that cable. Ugh! Even with the steel braid sleeve it was big and unsightly. And you need one on each side for each light - it was not pretty. For me that was a put off and I am going to pass on them for now. I am hoping that some really bright LED driving lights make their way to market that don't require as much current and as such can share a smaller single wire that I can tie off to the brake line.

So I decided to go with Radianz LEDs to replace my standard turn signal bulbs front and rear and convert the headlight to HID. I'll run with that and see how I like it. I can always go back and add the motos later.

Mike
Logged
Fullsac 1.75" Baffles / TTS / Lyndall Z+ Brake Pads / H-D LED Headlight / CeeBailey Windshield
Pages: 1 [2]  All
 

Page created in 0.139 seconds with 21 queries.