Where did you get the reflectors from?I got them on Amazon.
https://www.amazon.com/dp/B0B495XB9G?ref=ppx_yo2ov_dt_b_product_details&th=1
91
on: April 28, 2024, 08:33:21 AM
|
||
Started by ChopperPilot - Last post by FLSTFI Dave | ||
Where did you get the reflectors from?I got them on Amazon. https://www.amazon.com/dp/B0B495XB9G?ref=ppx_yo2ov_dt_b_product_details&th=1 |
92
on: April 28, 2024, 08:31:56 AM
|
||
Started by caltec - Last post by trippy | ||
The only problem with getting a new Engione is, you are going to have the same lifters and valve springs, and dont forget the inner cam bearings, so to get the engine reliable, you need to change them out before it goes bang.
|
93
on: April 28, 2024, 08:22:43 AM
|
||
Started by caltec - Last post by JCZ | ||
Welcome to the board from Arizona.
|
94
on: April 27, 2024, 08:47:19 PM
|
||
Started by caltec - Last post by BigLock | ||
Welcome from the Tar Heel state!!!
|
95
on: April 27, 2024, 08:17:05 PM
|
||
Started by caltec - Last post by D-N-D | ||
Welcome from PA !!!
Dante |
96
on: April 27, 2024, 06:41:17 PM
|
||
Started by caltec - Last post by Boatman | ||
Welcome to the site. Sad for your issues. At least you have a warranty. A tappet is another name for a lifter. Basically now they need to order you a new engine and oil pan baffle assy as metal has went thru the motor. Sadly all 110’s experience lifter failure at some point due to excessive valve spring pressure mostly. Your motor came with SE lifters but they are t any better than stock. A lot of people on here change lifters on a 110 every 15-20,000 miles. Most go with aftermarket. My 14 failed at 18k and put in S&S lifters. Good luck. Demand a new engine.
|
97
on: April 27, 2024, 06:33:24 PM
|
||
Started by caltec - Last post by caltec | ||
I bought a 2015 SG CVO with 20k miles from the locaql stearlership. Rode the bike for less than 100 and noticed some clanking noise coming from the engine. I took it back to the dealer and was told it sounded like a bad bearing. I was pissed. They will have to tear down the enginge to make sure. A week later they call and said there was a bad tappet and oil pump failure. They said "Good News, its covered under your extended warranty you purchased" I felt like S*$t. 2 weeks later today they call and said they put it back together and took for test ride but the bike "sputtering" and the tech is off for 2 days and will work on it when he gets back to work My reaction: WTF? Ok my question to the group when there is a tappet failure does that me the lifters are also bad and should be replaced?
|
98
on: April 27, 2024, 06:20:12 PM
|
||
Started by caltec - Last post by caltec | ||
Hello, Thank you for the addition and looking forward to all the valuable information in this group. I have a 2015 StreetGlide CVO
|
99
on: April 27, 2024, 05:38:58 PM
|
||
Started by CVOJerry - Last post by fastfreddy | ||
yup .... only way to measure gains or loss, were you located may be some one can point you to a tunner in your area
|
100
on: April 27, 2024, 03:55:38 PM
|
||
Started by iski - Last post by naitram | ||
wish i had known youd be coming through my area
|