www.CVOHARLEY.com
CVO Technical => Intake/Exhaust/ECM => Topic started by: Hekterr on June 30, 2020, 09:53:50 PM
-
Hello,
I am in possession of. SE 58mm cable drive throttle body and would like to install it on a 2007 Roadglide.
1. The new throttle body has a Bosch air temp manifold pressure all in one sensor that has 4 pin plug.
2.my bike has separate air temp and manifold pressure sensors with 2 separate plugs..
Has anyone successfully installed this combo? There is a total of 5 wires hooked up on the original wiring harness andonly 4 on the new 58TB.
The Bosch plug and pins can be bought from HD for about a 2015 RG...
Will the sensor values be the same to the 2007 ecm? Can sensor values, if necessary be recalibrated via TTS Mastertune?.
I’m thinking the original 2 plug 5wire setup has 2 ground wires which could be combined on the 4 wire newer sensor?
Any thoughts or help greatly appreciated, Dave