www.CVOHARLEY.com

CVO Technical => General CVO discussion => Topic started by: JONNIEROCK on May 03, 2021, 09:33:45 PM

Title: Accessory Switch
Post by: JONNIEROCK on May 03, 2021, 09:33:45 PM

  I've got a 16 CVO SG. When I hold down the trigger switch (description in manual) to engage to accessory mode, seems like I always end up resetting one of the trip meters, which I use for oil changes and mileage. Anyone have a trick for operating this switch without resetting one of the meters? I done it, but it's a nano second between doing it right and not.
             Thanks Jonnierock

Title: Re: Accessory Switch
Post by: lorenc on May 05, 2021, 02:51:37 PM

I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.

Title: Re: Accessory Switch
Post by: motor1 on May 05, 2021, 03:21:32 PM

Quote from: lorenc on May 05, 2021, 02:51:37 PM

I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.

Same here, if you I am in odometer display or miles till empty I can avoid a trip reset.

Title: Re: Accessory Switch
Post by: spence on May 06, 2021, 06:24:25 AM

I would get caught in the dreaded reset when exiting aux mode, I found that while still in aux mode I cycle all the way through back to total mileage then exit it and all seems well since doing that.

Title: Re: Accessory Switch
Post by: brianfl67 on May 06, 2021, 06:55:38 AM

When you're holding your button down wait for the gauge needles to jump then let go works for me

Sent from my SM-N975U using Tapatalk

Title: Re: Accessory Switch
Post by: JONNIEROCK on July 26, 2021, 10:21:37 PM

  Thanks for the help. Leaving on total mileage is the ticket. If it's on any trip mileage,  i always seem to hold it down a nano second to long, thus resetting it.