CVO Technical > General CVO discussion

Accessory Switch

(1/2) > >>

JONNIEROCK:
  I've got a 16 CVO SG. When I hold down the trigger switch (description in manual) to engage to accessory mode, seems like I always end up resetting one of the trip meters, which I use for oil changes and mileage. Anyone have a trick for operating this switch without resetting one of the meters? I done it, but it's a nano second between doing it right and not.
             Thanks Jonnierock

lorenc:
I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.

motor1:

--- Quote from: lorenc on May 05, 2021, 02:51:37 PM ---I always make sure Im on the total miles or the Remaining miles. Thats my work around that works but its not perfect. Depends if I remember to change to one of those before I turn off the bike.

--- End quote ---
Same here, if you I am in odometer display or miles till empty I can avoid a trip reset.

spence:
I would get caught in the dreaded reset when exiting aux mode, I found that while still in aux mode I cycle all the way through back to total mileage then exit it and all seems well since doing that.

brianfl67:
When you're holding your button down wait for the gauge needles to jump then let go works for me

Sent from my SM-N975U using Tapatalk

Navigation

[0] Message Index

[#] Next page