CVO Technical > Drive Train
Hydraulic Clutch Line Position Adjustment
tunaman:
I need to adjust the hydraulic line on my bars just a little. If I crack the banjo bolt on the master cylinder to rotate the fitting a smidge, do I have to bleed the line?
Sorry, but new to the hydraulic clutch and it’s been so long since I had to muck with my brake line on my Fat Boy so I can’t recall.
ltank:
If it's loosened slightly just enough rotate it, I think your OK only if you don't squeeze the lever and no fluid is lost when slightly lessened. After every is tightened back up , test the clutch pull with motor off then again with motor running.
tunaman:
Thanks! I’ll give it a shot, and if I have to bleed it then I’ll just replace the fluid anyway.
Appreciate the response.
rayson56:
You should be fine, just check you level when finished.
ultra13:
X2 56......
Navigation
[0] Message Index
[#] Next page
Go to full version