Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[LarryB]

Hey all, while removing my A/C to install the big sucker, I found that two of the rubber O rings were shot. these were the ones on the bolts that go into the heads. they have rings on the inside and outside of the bolt. both outside one where bad. might want to check yours.
Also, while lining up my BS backing plate, there is a gap between it and the head mounts. it is tight against the throttle body but a 1/4in or so gap is there,
What's the FIX?

[HDBaggerDave]

Sorry, can't help.  Just got my heavy breather and haven't started yet...but you can bet I'll be watching this thread closely.  Good luck!

[LarryB]

Ok, got the fix, the serg does not have the throttle body support bracket as others do. that bracket takes up the 3/16 that I need. was on the phone with Arlen Ness, well not him really just one of the engineers, and we figured it out. Damn if it's not a HD part, 14 bucs, be here monday

[HDBaggerDave]

Which Big Sucker did you go with?  Not HD's?

[LETS_ROLL]

ok here it goes

Let's Roll

[LarryB]

Arlen Ness makes the bike sucker. HD is the heavy breather.
i am not taking a picture of something that isnt there. I'll send a pic of the bracket when I get it.