www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Terminal Velocity II  (Read 925 times)

0 Members and 1 Guest are viewing this topic.

seultrarider

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 64
  • FLHRSEI.ORG
Terminal Velocity II
« on: February 27, 2006, 12:30:45 PM »
would like feedback on this from those who have it on their bikes. was it difficult to install? any problems? would you recommend? plus any other comments. thanks in advance....
Logged

bigmanken

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 64
  • They think I have lost my mind.
Re: Terminal Velocity II
« Reply #1 on: February 27, 2006, 05:52:03 PM »
Check page two on the twin cam board. There is a thread on mapping vs. fuel management. You should find it interesting.

I had the Terminal Velocity installed. No regrets. For my needs, it has done well.
Logged

seultrarider

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 64
  • FLHRSEI.ORG
Re: Terminal Velocity II
« Reply #2 on: February 27, 2006, 09:47:51 PM »
where did you get it installed?
Logged

skidlyman

  • Newbie
  • *
  • Offline Offline
  • Posts: 28
  • FLHRSEI.ORG
Re: Terminal Velocity II
« Reply #3 on: February 28, 2006, 09:38:22 PM »
I too installed one on my FLHPI, at the same time installed Rinehart Tru-Duals and a Ness Big Sucker AC, noticeable differance in power and torque. All the parts were installed in about 4 hours taking my time.
Logged
 

Page created in 0.126 seconds with 22 queries.