Topic: front motor mount (Read 2519 times)

erniezap · « **Reply #15 on:** July 15, 2006, 10:26:44 AM »

Had the neck bearings adjusted and the "new" motor mount put in yesterday. There's a LITTLE more vibration at idle, but I see any difference in vibration at speed. I'm happy with it...

Crawdaddy · « **Reply #16 on:** July 15, 2006, 12:28:34 PM »

coincidence

I just got mine back from the 15K service this AM. They said my neck bearings were way out of adjustment and dry. I had them check that because I had such a hard time steering at slow speed in CC. They also checked my install on the motor mount, loosened it and retorqued to spec. The vibration I had at 3000 rpm is gone. When I looked at the air filter they replaced, the blue gasket at the bottom was torn and beat up. I think that happened due to the bad motor mount.

Wonder if that is the reason Jonga had trouble with is breather. [smiley=nixweiss.gif]

Author Topic: front motor mount (Read 2519 times)

erniezap

Re: front motor mount

Crawdaddy

Re: front motor mount