www.CVOHARLEY.com
Custom Vehicle Discussions => CVO™ TRI GLIDE => Topic started by: 2UP3DOWN on October 11, 2021, 08:56:58 AM
-
Hi All.
Recently traded up from a 2018 Tri Glide to a 2021 CVO Tri Glide.
My 2018 had a chrome Kuryakyn license plate bracket that I installed. Wasn't too hard as I recall. I am wanting to swap that over to the CVO but having trouble removing the lower part of the bracket (The section that has the wide horizontal reflector - that I also want to remove)… There are 3 Torx screws that hold that bracket on. Do I simply remove the torx screws.? Or do I have to disassemble the rear door hatch and remove the plastic cover/housing..?
Attaching a picture: Number 4 shows the 3 torx screws, however its not clear where they screw in to.. assuming the holes in number 18 might be threaded..