I bought a 2015 SG CVO with 20k miles from the locaql stearlership. Rode the bike for less than 100 and noticed some clanking noise coming from the engine. I took it back to the dealer and was told it sounded like a bad bearing. I was pissed. They will have to tear down the enginge to make sure. A week later they call and said there was a bad tappet and oil pump failure. They said "Good News, its covered under your extended warranty you purchased" I felt like S*$t. 2 weeks later today they call and said they put it back together and took for test ride but the bike "sputtering" and the tech is off for 2 days and will work on it when he gets back to work My reaction: WTF? Ok my question to the group when there is a tappet failure does that me the lifters are also bad and should be replaced?

Hello, Thank you for the addition and looking forward to all the valuable information in this group. I have a 2015 StreetGlide CVO

yup .... only way to measure gains or loss, were you located may be some one can point you to a tunner in your area

wish i had known youd be coming through my area

I agree it looks a lot better with the reflectors on it !!!!


Dante

This topic has been moved to Twin Cam.

https://www.cvoharley.com/smf/index.php?topic=125656.0

So I installed the new reflectors and the latch cover.  Installing the latch cover was a pain in the a**w.  Tough to get it lined up right, and a pain to get at the three tiny torx.

I think it looks better.

Where did you get the reflectors from?

So I installed the new reflectors and the latch cover.  Installing the latch cover was a pain in the a**w.  Tough to get it lined up right, and a pain to get at the three tiny torx.

I think it looks better.

When trying to get my reflector out of my saddlebag latch cover I did this.  So I ordered a replacement latch cover.  It came in quickly, I'm still waiting on a Pan America part I ordered 4 weeks before this one.

Just rolled over 7900 miles on mine so far.  Engine has been trouble free.