www.CVOHARLEY.com
CVO Technical => General CVO discussion => Topic started by: how2 on November 06, 2021, 02:40:56 PM
-
took a ride last week and then tried to start today will not start not even a clicking noise. everything comes on but the starter will not engage.cannot find out where is the starter relay on the bike. it is a 2019 cvo street glide. please help. battery is new
-
Check battery in remote?
-
Maybe a dumb question, but was the key fob close by?
-
Another stupid question, was the bike in neutral? I believe the neutral safety switch is going bad on my bike. Sometimes when I try to start it in gear and the clutch pulled in I get nothing, click it into neutral and then it starts.
-
did all that still nothing
-
Can you use a test light on the small wire on the starter to see if it lights up?
Confirm the battery is charged, cables are clean, loosen and re tighten them to confirm a good connection.
Also check the ground cable to frame connections.
-
the bike looks like it will start but does not. even including moving the key fobs away and using the pin to try to start still nothing HELP it looks like some kind of safety switch is stoping the bike from starting . just shut it off and didn't start a week later and this happened.
-
Battery is low. Charge and try again.
-
no brand new ion battery
-
no brand new ion battery
Have you tested it? Not saying it's dead or bad. But if it were it would not be the first dead new battery many of us have ever seen.
-
the 1 wire on the starter does not have power when the starter switch is activated.
-
the 1 wire on the starter does not have power when the starter switch is activated.
Which "1" wire? The big cable on the battery post on the starter? If so it's a dead battery and that one should be hot all the time. Or the smaller green wire that plugs in? If so that's the wire that's triggered when you push start button. Should only be hot when you push the start button. If it's not hot then check your starter relay or handlebar switch.
-
tired new switch and new BMC mod still nothing. does anybody know where that wire from the starter goes?
-
Might have either a loose ground wire. Or it could be corroded
Sent from my iPhone using Tapatalk
-
Had that problem on my 09 xr 1200
Sent from my iPhone using Tapatalk
-
NO POWER ON THE TRIGGER WIRE WHEN PRESSING THE START SWITCH. HELP WHERE ID THE RELAY ON A 2019 CVO STREET GLIDE I CANNOT FIND IT ANY WHEAR.
-
In the fuse panel.
-
just a thought, but try the KILL switch. I always shut mine off & onn with the kill switch. maybe you hit it by mistake
-
There is no fuse box for the starter
-
There is no fuse box for the starter
Not a separate starter fuse panel. The bike has no such panel. In the main fuse panel.
-
it has fuse panel but all fuses are good
-
Do this to confirm battery and starter are ok.
Put bike in neutral, cycle on off on to listen for fuel pump operation.
If you can hear the pump cycle, confirm bikes in neutral and use a jump wire from main battery cable at starter to the igniter wire ( small wire on solenoid) crank over the engine and see if it starts.
Did you check for codes?
-
Check battery in remote?
Does your fuel pump prime? If your starter isn’t spinning,it should be fairly easy to diagnose.
-
did all of that and everything works? no juice on the wire at the starter ,the trigger wire
-
sounds like fob batteries to me. Ck new ones too before install.
-
all-new batt
-
it has fuse panel but all fuses are good
Check the relay too. It's in the panel but it's not a fuse.
-
just to let everybody know it was the BCM MODULE. BUT HOW DO REPROGRAM THE SECURITY SYSTEM