CVO Technical > General CVO discussion

Bullet Rear Signal Lens - No slot for removal

(1/1)

GregMan241:
Hi guys,

I have a 2006 flstfse2 and need to replace rear turn bulb......

The smoked lens cover (unlike the one on the front) does not have a slot to insert a screw driver to remove.

It spins with effort but does not unthread.

Any thoughts?  Don't want to turn this small job into a repair lol!

Thanks and cheers,

Greg.
2008 flhrse4
2006 flstfse2

Twolanerider:
It's a tension fit.  Just be brave and pop it off.

GregMan241:
LOL..... thanks for confirming it wasn't some other form of fastening.....

I got it off.... used a small putty knife with a very fine metal blade, was able to carefully insert and pry and didn't f things up....

thanks again and cheers,

Greg.

GregKhougaz:
Greg,

Just in case you did not know, the "slot" in the front signals is also to allow water / condensation to drain so make sure it is pointed down.  :2vrolijk_21:

Greg

Navigation

[0] Message Index