Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Jswerve]

I've taken apart several molex connectors but not sure how this type comes apart. It's part of my led light bar on my tour pak. Any one know?

[Jswerve]

.

[Jswerve]

.

[Jswerve]

Did some research on the good 'ol Net and found this video. It's an AMP Multilock BTW

[Jswerve]

[skratch]

for me what usually happens is i watch the video, think to myself, 'self, this can't be too bad'.  then i go out and futz with it for about an hour to an hour and a half.  then i get frustrated, give up, go back inside.  take a break for a few minutes and then go out and try again.  only this time, it seems like it just falls right out with no hassle. 

repeat for the next pin........ 

[Jswerve]

Same here lol

[Delta]

Got all the pieces in to do the tour pak light mod. After installing 3 wires into the AMP Multilock I decided to double check where I was putting the wires. Sure enough I was doing it bass ackwards. Fought with those damn pins for an hour then found this thread. I got 2 of the 3 pins out. No way was the last one cooperating. Had to snip the wire. Off to the dealer tomorrow for another connector and then beg them for a new pin and hopefully sweet talk them into crimping it on the wire for me. Man, I hate being all thumbs. Yep, I double checked the position of the plug before I started, got interrupted then the mistake happened.

[Jswerve]

Got all the pieces in to do the tour pak light mod. After installing 3 wires into the AMP Multilock I decided to double check where I was putting the wires. Sure enough I was doing it bass ackwards. Fought with those damn pins for an hour then found this thread. I got 2 of the 3 pins out. No way was the last one cooperating. Had to snip the wire. Off to the dealer tomorrow for another connector and then beg them for a new pin and hopefully sweet talk them into crimping it on the wire for me. Man, I hate being all thumbs. Yep, I double checked the position of the plug before I started, got interrupted then the mistake happened.

Hey glad I could help!!! I had some trouble really tried my patience but I got them all without damaging them.

[Delta]

The video was good. Hope I never have a need to watch it again. He makes it look so easy.

[Trapperdog]

They can be a bit perplexing on the first go around. Comes in handy when you need to do certain electrical additions or tear up parts of a harness.

[hubbz]

I found it amazing how much better a straightened out paper clip with a very sharp end on it works as opposed to one with a dull, blunt end on certain connectors!, lol,,,I imagine the right tool would work even better! hahaha