1
on: Today at 06:33:24 PM
|
||
Started by caltec - Last post by caltec | ||
I bought a 2015 SG CVO with 20k miles from the locaql stearlership. Rode the bike for less than 100 and noticed some clanking noise coming from the engine. I took it back to the dealer and was told it sounded like a bad bearing. I was pissed. They will have to tear down the enginge to make sure. A week later they call and said there was a bad tappet and oil pump failure. They said "Good News, its covered under your extended warranty you purchased" I felt like S*$t. 2 weeks later today they call and said they put it back together and took for test ride but the bike "sputtering" and the tech is off for 2 days and will work on it when he gets back to work My reaction: WTF? Ok my question to the group when there is a tappet failure does that me the lifters are also bad and should be replaced?
|
2
on: Today at 06:20:12 PM
|
||
Started by caltec - Last post by caltec | ||
Hello, Thank you for the addition and looking forward to all the valuable information in this group. I have a 2015 StreetGlide CVO
|
3
on: Today at 05:38:58 PM
|
||
Started by CVOJerry - Last post by fastfreddy | ||
yup .... only way to measure gains or loss, were you located may be some one can point you to a tunner in your area
|
4
on: Today at 03:55:38 PM
|
||
Started by iski - Last post by naitram | ||
wish i had known youd be coming through my area
|
5
on: Today at 11:27:50 AM
|
||
Started by ChopperPilot - Last post by D-N-D | ||
I agree it looks a lot better with the reflectors on it !!!!
Dante |
6
on: Today at 11:09:27 AM
|
||
Started by Fired00d - Last post by Fired00d | ||
7
on: Today at 09:10:47 AM
|
||
Started by ChopperPilot - Last post by OBB | ||
So I installed the new reflectors and the latch cover. Installing the latch cover was a pain in the a**w. Tough to get it lined up right, and a pain to get at the three tiny torx.Where did you get the reflectors from? |
8
on: Today at 08:49:34 AM
|
||
Started by ChopperPilot - Last post by FLSTFI Dave | ||
So I installed the new reflectors and the latch cover. Installing the latch cover was a pain in the a**w. Tough to get it lined up right, and a pain to get at the three tiny torx.
I think it looks better. |
9
on: Today at 08:46:55 AM
|
||
Started by ChopperPilot - Last post by FLSTFI Dave | ||
When trying to get my reflector out of my saddlebag latch cover I did this. So I ordered a replacement latch cover. It came in quickly, I'm still waiting on a Pan America part I ordered 4 weeks before this one.
|
10
on: Today at 08:07:41 AM
|
||
Started by OBB - Last post by FLSTFI Dave | ||
Just rolled over 7900 miles on mine so far. Engine has been trouble free.
|