Topic: disconnecting power (Read 909 times)

nixobilly · « **on:** March 10, 2007, 10:06:32 PM »

Ok, just installed my new thundermax with autotune on my SE2. Have a question about the sticker I'm placing by the battery....

So if I need to remove the + from my battery, I should first remove the ECM fuse from the right hand block and then disconnect the battery....

After reconnnecting my battery, I should do the 30sec on/ 30sec off procedure without touching the throttle......

If i follow these instructions will all the data corrections I have via the autotune be lost or retained?

Thanks,

Mark

jdk20723 · « **Reply #1 on:** March 11, 2007, 05:18:11 PM »

Retained. They are stored within the module, connected to power or not. The only thing you need to do after interrupting module power is re-initialize the system to re-establish IAC and TPS "home" positions. JK

Author Topic: disconnecting power (Read 909 times)

nixobilly

disconnecting power

jdk20723

Re: disconnecting power